2D Flocking (Boids)

A 2D Boids simulation!

Controls

Tab: Opens and closes the config menu. Change these values to adjust boid behavior.

Left Ctrl + Left Click: Creates a static, circular obstacle. 

Right Click: Creates a destination that all the boids will flock towards. After arriving at the destination boids will go Idle and stop moving. A boid will remain idle until it is given a new destination.

Left Click: Removes the current destination.

NOTE:

To make all idle boids active:

1. Left Click to remove the current destination.
2. Press Tab to open the menu
3. Click the Reset button.

OR

1. Left Click to remove the destination
2. Right Click (Make sure to do it far enough away)
3. Left Click before any boids arrive at the destination.